Hello,
I'v got a problem with the printer M1, when I try to print, it starts to print way too high (around 2mm too high).
As a result, the filament is not on the bed and it just continue to extrude in the air.
I have the last firmware (Release dateļ¼2020-12-28 09:48:56), i tested it with cura provided and a the new version with information provided.
I also tested via SDcard and via usb.
Any solution?
I unboxed mine today and after the short setup, I am getting the same thing. Differentce is that mine is about 5mm+ above the bed and tries to print. Not working and no way to fix this so far..
UPDATE - I figured it out. You cannot use any other version of Cura than what is supplied with the printer on the SD Card. Printer runs like it is designed to using the included version of Cura.
I re-installed the MakerPI Cura and you are right, it works!
That's a bit a shame, because I've got 3 printers and I definitly prefer to use only one Cura but...
Thx again,
Hi
With the setting for other Cura versions from the manual
you simply have to set the Z to 1.6 in the 2nd line in the start G-Code
then it should work, at least that's how it is for me.
You can just try out a bit with the number after the point up or down
That's my attitude
G28; Home
G1 Z1.6 F6000; Move the platform down 3 mm
; Prime the extruder
G92 Z0 E0
Posted at 2021-2-24 21:33:14
Author