MakerPi M1 - Pause / User Input Gcode

2mas

Hi there,

I was trying to use Cura's functionality to have a Pause at Height ( to change the filament). But current Firmware (I believe) doesn't wait for input. When it comes to M0, it Pauses, waits for few seconds and resumes printing straight away.
No time for filament change. Can you please tell which gCode command to use? HEre is the code which had to stop printing:

1. ;TYPE:CUSTOM
   
2. ;added code by post processing
   
3. ;script: PauseAtHeight.py
   
4. ;current layer: 12
   
5. M83 ; switch to relative E values for any needed retraction
   
6. G1 F1500 E-5
   
7. G1 F300 Z3.6 ; move up a millimeter to get out of the way
   
8. G1 F9000 X190 Y190
   
9. G1 F300 Z15 ; too close to bed--move to at least 15mm
   
10. M104 S200 ; standby temperature
    
11. M18 S90 ; Set the disarm timeout
    
12. <b>M0 ; Do the actual pause</b>
    
13. M109 S200 ; resume temperature
    
14. G1 F1500 E5
    
15. G1 F199.998 E5
    
16. G1 F1500 E-5
    
17. G1 F300 Z3.6
    
18. G1 F9000 X39.515 Y50.64
    
19. G1 F300 Z2.6 ; move back down to resume height
    
20. G1 F1500 E5
    
21. G1 F900 ; restore extrusion feedrate
    
22. M82 ; switch back to absolute E values
    
23. G92 E696.98177
    
24. ;LAYER:12
    
25. ;TYPE:WALL-OUTER
    
26. ;MESH:BLU.stl

Copy the code

Alice

Hi friend,

Did you mean you want to change filament during printing or stop printing then you change filament?