Makerpi M1 - How configure new ultimaker cura for m1?

Jos3fpm

Please we need profile setting for use new ultimaker cura; the cura software comes with printer its a little be old.

Please can you send as a profile for new cura version or how can we configure on it.

Please.
Thanks.

2mas

Hi there, download latest manual from this website for M1 Last pages 16-19 are about this setup

Jos3fpm

2mas Posted at 2021-2-14 17:20
Hi there, download latest manual from this website for M1  Last pages 16-19 are about this setup : ...

Thanks but seem no work properly ...

akronyme

I agree, I tested it and it prints 2-3mm too high...

urnie

Hi
With the setting for other Cura versions from the manual you simply have to set the Z to 1.6 in the 2nd line in the start G-Code then it should work, at least that's how it is for me.

You can just try out a bit with the number after the point up or down
That's my attitude

G28; Home
G1 Z1.6 F6000; Move the platform down 3 mm
; Prime the extruder
G92 Z0 E0

G1 F200 E3
G92 I0

Alice

You can download Cura 4.8 now

TerryPro

Here is what worked for me.
As stated above, initially set up a new printer profile using the latest manual and instructions on pages 16-19. In the "Start GCode" and "End GCode" sections, simply copy/paste the entries from the older Makerbot Cura M1 profile into the new Cura M1 printer profile and save it.
As well, I had noticed in the new Cura that my 3D model was floating approximately .3mm above the printing plate when using rafts (which normally work really well). I noticed that there are many settings that are initially hidden from the user (Settings > Configure Settings Visibility). One of these is "Build Plate Adhesion > Raft Air Gap". One selected to be visible, I noticed that it was set to .3mm. I decreased that to 0 and the print model wasplaced directly on the raft, where it should be.

sunshine

ok ,how is the M1 printer use now?

admin

HI friend,if you have any questions,pls Email to sales03@soongon.com