MakerPi 3d BBS

Title: Settings for new cura version Makerpi M1 [Print This Page]

Author: Jos3fpm Time: 2021-1-31 19:05
Title: Settings for new cura version Makerpi M1
Can u post setting to configure Makerpi M1 printer in new verison of cura software? Please
Thanks.

Author: urnie Time: 2021-3-14 20:35
Hi
With the setting for other Cura versions from the manual you simply have to set the Z to 1.6 in the 2nd line in the start G-Code then it should work, at least that's how it is for me.

You can just try out a bit with the number after the point up or down
That's my attitude

G28; Home
G1 Z1.6 F6000; Move the platform down 3 mm
; Prime the extruder
G92 Z0 E0

G1 F200 E3
G92 I0

Author: TerryPro Time: 2021-8-21 21:49
Last edited by TerryPro In 2021-8-22 00:10 Editor

Posted in another thread.
Here is what worked for me.
As stated above, initially set up a new printer profile using the latest manual and instructions on pages 16-19. In the "Start GCode" and "End GCode" sections, simply copy/paste the entries from the older Makerbot Cura M1 profile into the new Cura M1 printer profile and save it.As well, I had noticed in the new Cura that my 3D model was floating approximately .3mm above the printing plate when using rafts (which normally work really well). I noticed that there are many settings that are initially hidden from the user (Settings > Configure Settings Visibility). One of these is "Build Plate Adhesion > Raft Air Gap". One selected to be visible, I noticed that it was set to .3mm. I decreased that to 0 and the print model wasplaced directly on the raft, where it should be.

Author: sunshine Time: 2021-8-26 15:29
OK,thank you.How is your machine using now?

Author: MeritzPeritz Time: 2021-10-6 15:13

TerryPro Posted at 2021-8-21 21:49
Posted in another thread.
Here is what worked for me.
As stated above, initially set up a new printe ...

Can you share your profile and which Cura version you run?

Would be nice to get a more noob friendly guide as to how install/create a profile for this printer

i am willing to work on it and share it later via github for everyone to import, the "Air Gap" setting for support should be build in the profile or added as a picture :-P

THANK YOU!

Author: admin Time: 2025-1-11 18:14
HI friend,if you have any questions,pls Email to sales03@soongon.com

Welcome MakerPi 3d BBS (https://enbbs.makerpi3d.com/)