MakerPi 3d BBS

Title: [Q&A] Filament Stick On K5 Plus [Print This Page]

Author: admin Time: 2020-10-21 14:00
Title: [Q&A] Filament Stick On K5 Plus

Notice：Please slice with MakerPi Cura,and sure the filament is PLA.

Please turn on the printer and return to zero,check if the fan of E motor can work or not,if it canwork,please share a video to our aftersales support.

If the fan can’t work normally,please tell us,we will give you a new fan for repairement.

Specific operation:

“Prepare”“Auto Home”，check if the cooling fan work normally.

[attach]12[/attach][attach]13[/attach]

[attach]14[/attach] [attach]15[/attach]

If you find the cooling fan of E motor can’t work(left fan works normally),Please do the following steps（With the power off!）

1.Eliminate filament stuck caused by cooling fan of e motor.

1.1. Take off the screws on the motor case.

[attach]16[/attach][attach]17[/attach]

1.2. Take off the motor case,disassemble the connect plate of E motor

[attach]18[/attach][attach]19[/attach]

1.3. Exchange the fan terminal of E motor (the white terminal is the cooling fan of e motor).

[attach]20[/attach]

1.4.After replacing the two terminals, reinstall the E motor cover (Do not tighten the fixing screws!)

[attach]21[/attach]

1.5. Power on the printer,click “Prepare” and “Auto home”,check if the cooling fan can work normally or not.

[attach]22[/attach]

2.If it can’t work normally,then we know the fan is broken,need change a new cooling fan of E motor.

2.1.Unplug the cooling fan terminal of e motor.

[attach]23[/attach]

2.2.Use an Allen wrench and an open-ended wrench to remove the e motor fan.

[attach]24[/attach]

2.3. Replace the new fan. Then connect the fan terminal back to the adapter plate, and install the E motor cover back to the printer.

3.0. If the fan still can’t work, consider replacing the E motor adapter plate.

3.1Remove the E motor adapter plate, and unplug all terminals on the adapter plate.

[attach]25[/attach][attach]26[/attach]

3.2.Replace the new adapter board and connect all terminals.

[attach]27[/attach]

3.3. Replace the adapter plate and E motor cover in the order of removal, and turn on the printer to check whether the cooling fan of E motor works normally.

4.All the above operations can be photographed or recorded as appropriate. Please contact after-sales support if you don't understand or have any questions about the above operations.

Welcome MakerPi 3d BBS (https://enbbs.makerpi3d.com/)