MakerPi 3d BBS

Title: [Q&A] K5 Plus Manual Leveling [Print This Page]

Author: admin Time: 2020-10-19 16:52
Title: [Q&A] K5 Plus Manual Leveling

When automatic leveling does not work accurately, the following steps can be performed:

1. Power off the machine, Loosen the four screws on the left and right sides of the platform so that the platform can slide up and down freely, as shown in the picture：

[attach]9[/attach]

2. Push the platform close to the nozzle (the distance of a business card), and then tighten the four screws, as shown in the picture：

[attach]10[/attach]

3. Unlock the motor after turning on the machine to zero，Based on the business card, place between the platform and the nozzle (the spacing is just enough to pass the business card)，adjust the four corners of the platform separately.

[attach]11[/attach]

Welcome MakerPi 3d BBS (https://enbbs.makerpi3d.com/)